i know i might see some of you on OT alot but i had the strangest idea to post this stuff in the proper sections for a change hahaha
I had some nitrous stuff laying around and i decided, know what, its about time i juiced my bike... So
I had a 4an feed line made at the local hydraulics store, a custom 5ft'er, then i used a NX piranha nozzle, and a NX mainline Solenoid(75hp rating) since it was the smallest one i had, and the bike wouldn't see over a 30 shot
i drilled slightly smaller than the size of the nozzle in my ram air tube under my gauge cluster and just screwed the nozzle in tight, i had to purchase a 90degree 3an fitting because the line was right in front of my gauge cluster... it had to be run like this because the 636 has a divider in the neck of the steering column, if you try to spray left or right of the ram air tube it will only go to cyls 1-2 or 3-4 could be very bad causing a lean condition resulting in lost pistons hahah
here you can see the line and nozzle.
here is a pic from the dyno tuning day!
using the 10lb bottle so we wouldent run out of nawz!
ordered a smaller bottle that would fit in my swingarm
bottle looking good in there!
here is a video of the nitrous dyno day party.
http://youtube.com/watch?v=2QW5z1tIi1Y
basically the bike picked up a good amount of power table as follows
110hp stock NA
122hp 12 shot
133hp 20 shot
144hp 30shot!
Edited by denmah (07/12/07 06:18 AM)
_________________________
Mott -
www.sloppymechanics.com "I'm gonna denmah my gf tonight." LNXGUY
"Denmah has the most consistently entertaining posts of any member here" - Adam G
"denmah: because canada can't be the only country with a moof" - jsmonet
"LOL, you really are my hero denmah. You actually do the things the rest of us dream or bullshit about." - 98_1LE